Get Startedwith PocketCloudGet Started with PocketCloud

Thank you for choosing StationPC.
Follow this quick-start guide to easily install and begin operating your PocketCloud

M.2 SSD Installation

Ensure the device is powered off and the indicator light is off.
1

Ensure the device is powered off and the indicator light is off.

Using the screwdriver to loosen the screws and remove. the cover.
2

Using the screwdriver to loosen the screws and remove. the cover.

Insert the M.2 NVMe SSD into the slot and tighten the screw.
3

Insert the M.2 NVMe SSD into the slot and tighten the screw.

Replace the cover and tighten the screws.
4

Replace the cover and tighten the screws.

Ensure the Dock is disconnected from the power source.
1

Ensure the Dock is disconnected from the power source.

Using the screwdriver loosen the screws and remove the bottom panel.
2

Using the screwdriver loosen the screws and remove the bottom panel.

Insert the SSD into the slot and tighten the screw.
3

Insert the SSD into the slot and tighten the screw.

Install the bottom panel back and tighten the screws.
4

Install the bottom panel back and tighten the screws.

Download and Install theStationCloud App

Click Here to Download the StationCloud App
Across All Your Devices

Download

Initialize PocketCloud

1

Register Device: Launch the StationCloud app and select "New Device Registration."

2

Pair & Confirm: Find your device in the scanned list and confirm the prompt on the PocketCloud to begin.

3

Network Sync: Ensure both devices are on the same LAN. Connect via Ethernet (via dock) or follow the prompts to configure Wi-Fi.

4

Auto-Update: The system will automatically check and install the latest firmware if available.

5

Admin Setup: Create your Administrator Account.

6

Remote Access (Optional): Enable remote access now or configure it later in "User Management."

7

Done! Your PocketCloud is ready to use. Enjoy!